Bu ürünün kampanyalı satışı stoklarla sınırlıdır. Bir tüketici bu kampanya stoğundan maksimum 10 adet satın alabilir.
Çiçeksepeti kampanya koşullarında değişiklik yapma hakkını saklı tutar.
Ürünün iade politikasını öğrenmek için tıklayın.
Bu ürün ALKATRONİK tarafından gönderilecektir.
Bu satıcının ürünlerinde geçerli 350,00 TL Üzeri Kargo Bedava
Bu Satıcının Tüm Ürünlerini Görüntüle
Ürün sayfasında gördüğünüz fiyat bilgileri, satıcı tarafından belirlenmektedir.
ST ST-LINK V2 Arm Mcu Jtag SwimSwd Programlayıcı Debugger
Stm8 Stm32 Mcu Microcontrollers Mini Usb Icsp in Circuit Programmer Emulator
Orijinal ST üründür.
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD-STM8) or ST Visual Programmer (STVP-STM8) software, or with integrated development environments from third-parties.
STM32 applications use the USB full-speed interface to communicate with the STM32CubeIDE software tool or with integrated development environments from third-parties.
Features:
- 5 V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- SWIM specific features
- 1.65 V to 5.5 V application voltage supported on SWIM interface
- SWIM low-speed and high-speed modes supported
- SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
- SWIM cable for connection to the application via an ERNI standard vertical or horizontal connector
- SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
- JTAG specific features
- 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs
- JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
- Direct firmware update feature supported (DFU)
- Status LED which blinks during communication with the PC
- Operating temperature -10C to 70C
Paket içeriği :
- ST-LINK V2
- USB standard A to mini B cable
- JTAG or SWD and SWV flat ribbon with a 20-pin connector
- SWIM flat ribbon 4-pin, 2.54 mm
- SWIM flat ribbon with a standard ERNI connector
Ürün tanıtım ve destek sayfası
